HP Integrity NonStop H-Series - Manual (Page 135)

Establishing Column Headings
Creating an Oversized Table
058060 Tandem Computers Incorporated 5–23
Using RULER to Determine Placement
Using the next example as a guide, follow these steps to determine
placement for the headings in the table.
First, put in one set of row headings for each department; follow these
steps:
1. Put the cursor on the line containing the widest entry. Press RULER.
Use the RULER to judge where to start the column heads. Start at
column 20; use the arrow key to move the cursor there.
2. Make sure the cursor is in column 20 of the line containing the words
“Design and layout.” Press RULER to remove the ruler. Next, press
LINE. Then press INSERT.
3. Type the word “ACTUAL.” Press INSERT again. Then, move the
cursor back to column 20 and type “BUDGET” just above “ACTUAL.”
4. Next, to put in the column headings, move the cursor up to the first line
in the file. With LINE still on the status line, press INSERT four times.
This creates a space for two levels of headings.
5. Space over to column 30 (you may have to press RULER again to show
you where it is). Type the first column heading, “SALARIES.”