HP Integrity NonStop H-Series - Manual (Page 69)

The Options Part of the Profile
Customizing TEDIT for a Columned List
058060 Tandem Computers Incorporated 3–3
Press the RULER key again to make the ruler disappear. (Actually, you
could press any function key to make the ruler disappear.) Press
RETURN to
move to the next line. Press RULER again to determine where to place the
two column headings shown in the next example. Type the headings at 10
and 30 as shown.
AGENDA
8:00 Presentations by Department Heads
name department
....+....10...+....20...+....30...+....40...+....50...+....60...+....70...+....
Second column of list
Third column of list
First column of list
Setting the Tab Stops Before you type any more lines, you can set the tab stops in order to tab to
the columns as you type them. Find the key labeled TAB on the template
and press it a few times. You see that the tab stops are set at every eight
characters. To reset the tab stops, follow these steps:
1. Look on the template and locate the key labeled RECONFIGURE
OPTIONS. Press it. TEDIT displays the information shown in
Figure 3-1. These are the options TEDIT uses when you edit; you can
customize these options by creating and saving your own profile.
Highlight The Options Part of the Profile
A profile consists of all the settings for options and function keys that
appear on the RECONFIGURE OPTIONS screen and the RECONFIGURE
FUNCTION-KEYS screen. The original settings, called default settings, are
shown in the default profile illustrated in Figure 3-1. Your TEDIT contact
assigns the settings you start out with; yours could be different than the
defaults shown in the figure. You can change the default settings by
changing the assignments on the RECONFIGURE OPTIONS screen,
discussed here. The RECONFIGURE FUNCTION-KEYS screen is discussed
in Section 4.