HP Integrity NonStop H-Series - Manual (Page 81)

Identifying the Profile
Customizing TEDIT for a Columned List
058060 Tandem Computers Incorporated 3–15
Saving and Using
the Profile
Now that you have finished editing the agenda, the next step would usually
be to exit from the file. But, you made some changes to the tab stops in the
profile that you might want to save. If you save this profile, you can use it
again when you edit the agenda or if you create another agenda in the same
format. If you do not save the settings, they are permanently erased when
you exit from the file. You can save these settings by using the
SAVEPROFILE command.
Identifying the Profile Before you save the profile, you should identify it by writing comments in
the Remarks field on the RECONFIGURE OPTIONS screen. Follow these
steps:
1. Press the RECONFIGURE OPTIONS key.
2. The cursor is on the line labeled “Remarks.” Starting at the cursor
position, type something on the Remarks line that you can use to
identify the profile later. Just type over the remarks that are there now.
Here is an example of what to do for the agenda profile:
Profile * from $SYSTEM.SYSTEM.TEDPROFL, created 18JUN87.
Remarks: Tabs at 10 & 30
Align Width: 70 Auto Word Wrap : ON
Overlap (0-12): 2 Exit Confirmation: ON
Paragraph Lines: 6 Auto Renumber: ON
Printer Page Size: 0 RETURN Function: ON
Blank Fill on 3270: ON
Tab Stops (2-239): 10 30
Word Stops: " !""#$%&()*+,./;<=>?@[\]_{|}~"
Write remarks
about what is in
the profile here.
3. Press RECONFIGURE OPTIONS again to exit from the
RECONFIGURE OPTIONS screen.