HP Integrity NonStop H-Series - Manual (Page 143)

Using the SETPROFILE Command to Set Tab Stops
Creating an Oversized Table
058060 Tandem Computers Incorporated 5–31
Follow these steps to use the REPLACE response lines to insert some
vertical rules into the table:
1. Before you start, make sure that auto word wrap is set to OFF. You can
check by pressing the RECONFIGURE OPTIONS key.
2. Position the cursor in column 19 of the line containing the column
headings. Column 19 is where you want to insert the first vertical rule.
3. Press the REPLACE key. When the response lines appear, type the
information you see in the following example exactly as shown.
Replace: ""
With: "|"
In lines: */L
In columns: *:*
Options:
The column the
cursor is in
Replaces a null
character ("") with
a vertical bar (|).
*/L inserts rules throughout the
rest of the file. To insert rules
one screen at a time use */B.
4. Press REPLACE again. TEDIT inserts a vertical bar in the column
where the cursor is (column 19) from the line the cursor is in through
the last line in the file. The file should now look like the following
example; only part of the file is shown.
SALARIES EQUIPMENT SUPPLIES
|
Administration |
(Yuen) |
|BUDGET
|ACTUAL
---------------------------------------------------------------------------
Design and layout |
(Medici) |
|BUDGET
|ACTUAL
---------------------------------------------------------------------------
Editing |
(McAdams) |
|BUDGET
|ACTUAL
---------------------------------------------------------------------------
Finance |
(Riveira) |
With the cursor here,
press REPLACE.
|