HP Integrity NonStop H-Series - Manual (Page 84)

Using the Default Profile
Customizing TEDIT for a Columned List
3–18 058060 Tandem Computers Incorporated
Highlight Using the Default Profile
To use the default profile, give the USEPROFILE command and fill in the
response lines as shown in the following example.
Profile Name: * Profile File: $SYSTEM.SYSTEM.TEDPROFL
Type this file
name here.
Type an asterisk (*)
for the profile name.
To avoid having to type the profile file name every time you want to use the
default profile, save the default profile on your own default volume and
subvolume. You do this by giving the SAVEPROFILE command and
typing * (star) in the Profile Name field. The next time you start a TEDIT
session, use the above procedure to save the default profile before you
make any changes to the RECONFIGURE OPTIONS screen.
Deleting the Profile When you no longer want to save the profile, use the following procedure
to delete the profile. Follow these steps:
1. Press *C.
2. On the response line, type PURGEPROFILE (or simply PU), then press
*C.
3. When the second set of response lines appears, type the name of the
profile you want to delete.
Note There is a shortcut you can use to give the profile commands: You give the entire command
on the *C response line. This shortcut is especially useful if you change profiles often when
you are editing. There is another shortcut—the SETPROFILE command—that allows you to
change the settings in the profile quickly, but not necessarily save them for later use. Both
shortcuts are discussed in Section 5.