Job status messages – HP Designjet T2500 eMultifunction Printer series User Manual
Page 118
To make more than one print of a non-printed job in the queue from the front panel, select the job and
choose Copies, then specify the number of copies required. This overrides any value set by your software.
NOTE:
If Rotate was On when you sent the file, every copy will be rotated.
NOTE:
You cannot use this method for PCL3GUI jobs. To reprint old jobs that are PCL3GUI, you may be able
to use your operating system's printer spooler, if you have already set the spooler to save old jobs. This
facility depends on your operating system.
NOTE:
When reprinting a print job, you cannot change the print settings, because the job has already been
rasterized.
Job status messages
These are the possible job status messages, approximately in the order in which they may be seen:
●
Receiving: The printer is receiving the job from the computer
●
Waiting to process: The job has been received by the printer and is waiting to be rendered (for jobs
submitted through the Embedded Web Server only)
●
Processing: The printer is parsing and rendering the job
●
Preparing to print: The printer is performing writing system checks before printing the job
●
Waiting to print: The job is waiting for the print engine to become free to proceed with printing
●
Waiting for nest: The printer is set up with Nesting=On and is waiting for other jobs in order to
complete the nest and proceed with printing
●
On hold: The job was sent with the on hold for preview option and is on hold
NOTE:
Do not send a job for preview with more than 64 pages, this may cause the driver software to
crash.
NOTE:
If the printer hangs up while printing a job, and the queue facility is turned on, the partially
printed job will appear in the queue as on hold when the printer is next turned on. When you resume the
job, it will start printing at the page at which it was interrupted.
●
On hold for paper: The job can't be printed because the right paper is not loaded in the printer. Load the
required paper, see
, and click Continue to resume the job
●
On hold for accounting: The job can't be printed because the printer requires all jobs to have an account
ID: enter the account ID and then click Continue to resume the job
TIP:
●
On hold for stacker: The stacker is open, jammed, or full
●
On hold for manual mode: You must go to the front panel to activate manual mode
●
Printing
●
Drying
●
Cutting paper
●
Ejecting page
●
Canceling: The job is being canceled, but will remain in the printer job queue
●
Deleting: The job is being deleted from the printer
108 Chapter 12 Job queue management
ENWW