HP TopTools - Manual (Page 31)

HP Toptools for Unicenter User Guide
Figure 3-17. It may take some time for agent checks to update map status.
Even though you may indicate that the Ping Agent should be monitored on HP Netserver classes, it will take another
5 minutes before the next round of ping checks are executed and the status of the Ping agent in the submap updated.
3.2.2 Running ResetDSM
You must run “resetdsm” after DSM wizard is executed.
Run “resetdsm” and “awservices start” to make these changes take affect:
1. At the DOS prompt enter:
resetdsm
2. Run HP Reclassification, World View-> HP Reclassification
3. Make sure the Setting entries on the Unicenter Event Management tab are "yes".
4. At the DOS prompt enter: unicntrl start all
Watch performance meter, this step may take 2-5 minutes. Wait. Do not do next step until the system stabilizes.
5. At the DOS prompt enter: awservices start
Watch performance meter, this step may take 10-15 minutes. Wait. Do not do next step until the system
stabilizes. Virtual memory consumption will grow.
Bring up 2-D or object view and look for Netserver Agents as depicted in the figure below. If agents are not present,
execute resetdsm and repeat steps 4 and 5.
Figure 3-18. The Netserver UniSpace has three Agents: WBEM Agent, Ping Agent, and NSAAgent.
The HPNetserver is a unispace now and is populated with agent icons for each SNMP agent loaded on the HP
Netserver. This can be seen in the Unicenter WorldView 2d map, 3d map, or NodeView. If an alert is received
from an agent, the agent color is changed and propagates up the hierarchy. The agent color is changed on the 2d
map, 3d map, and in the Node View. For more details on Unicenter’s DSM refer to Unicenter product
documentation.
Page 31