HP TopTools - Manual (Page 56)

HP Toptools for Unicenter User Guide
Figure 5-20. Users can modify the Storage Capacity alert levels by dragging the indicators.
The Tools page lists software resources available to administrators for managing HP Netservers.
The remainder of property pages (Configuration, Report, and Support) for Netservers is comparable to the Properties
pages shown for HP Vectras. See the Toptools for Servers documentation for full details.
5.7.3 Association with the hp toptools remote control card
HP servers with an HP Toptools Remote Control card installed have the associated card moved into the submap of
the server object that physically contains them. For more information on the management of servers using the HP
Toptools Remote Control card and management of the card, refer to the next section of this User Guide, “Managing
HP Toptools Remote Control Cards”.
5.7.4 Compiled MIBS
During installation of the platform bridge, current server MIBS are loaded into Unicenter. This means that you can
use the Unicenter Object Browser to GET and SET SNMP MIB variables for the servers. In addition, most SNMP
traps received from servers are now formatted within Unicenter’s Event Console.
5.7.5 Event and Status Monitoring through DSM
HP Toptools for Unicenter supports event management for HP servers through:
• Loading trap definitions for HP server traps as described in the section above.
• Automatically setting the trap destination on HP servers during the platform bridge discovery process
• Adding NSAAgent to DSM
A submap is automatically generated for each HP server. The NSAAgent icon is added to the submap. Status
conditions associated with the icon are propagated up to the server icon on the main map. The NSAAagent icon is
shown in the Figure 5-21.
Page 56