HP ProLiant DL740 Server - Manual (Page 87)

Installing Hardware Options, Non-Hot-Plug
To install a processor board option kit (with four processors) into the host module:
1. Back up all data on the server.
2. Shut down the operating system as directed by your operating system
instructions.
3. If the server was not powered down in the previous step, power down the server
(refer to Chapter 7).
4. Disconnect the power cords from the server.
5. Open the top access panels to access the host module (refer to Chapter 3).
WARNING: To reduce the risk of personal injury from hot surfaces, allow
the internal system components to cool before touching them.
6. Remove the processor board air baffle by pressing in the release tab (1) while
pulling the air baffle up (2).
Figure 4-3: Removing the processor board air baffle
HP ProLiant DL740 Server User Guide 4-5
HP CONFIDENTIAL
Writer: Anna Roberts File Name: e-ch4 Install Hardware Options Non Hot-Plug.doc
Codename: Expedition Part Number: 270854-002 Last Saved On: 6/17/03 2:07 PM