HP Surestore 64 Director Switch - Manual (Page 33)

config 21
CLI Com
m
a
nds
config
The config branch of the CLI command tree contains commands that set parameter values.
These values are not temporary (session) values, but are retained across power cycles.
The commands in the config branch can by used only by the Administrator.
Note that the config.zoning commands function in a different way from the other CLI
commands, which are single action commands that take effect immediately. A zoning
configuration is typically too complicated to be described by a single command, so the first
zoning command entered invokes a work area editor. The commands take effect on a
temporary copy of a zone set in the work area until the temporary copy in the work area is
activated to the fabric--or is discarded.
Because not all the verification of the zone set can occur on the temporary copy in the
work area, it is possible, however unlikely, that the copy of the zone set encounters no
errors until the zone set is activated to the fabric.
config.ip.ethernet
Syntax
ethernet ipAddress gatewayAddress subnetMask
Purpose
This command sets the Ethernet network settings.
Description
Note The Telnet connection can be lost when these Ethernet network settings are
changed.