HP Officejet 7410 All-in-One Printer - Manual (Page 52)

through the photos, one photo at a time. Press and hold or to move rapidly
through the photos.
Note You can also select photos by entering the index numbers of the photos you
want to print. Press the pound key (
# ) to specify a range: 21-30. Press OK
when you finish entering the photo index numbers.
3 Load photo paper face down in the back right corner of the input tray and adjust the
paper guides.
Tip If the photo paper you are using has perforated tabs, load the photo paper so
that the tabs are closest to you.
4 In the Photo area, press Print Photos to print the selected photos as borderless
prints.
Deselect photos
You can deselect photos from the control panel.
➔ Do one of the following:
– Press OK to deselect the currently selected photo shown in the display.
– Press Cancel to deselect all photos and return to the idle screen.
Print photos from a PictBridge-compatible digital camera
The HP all-in-one supports the PictBridge standard, which lets you connect any
PictBridge-compatible camera to the camera port and print JPEG photos contained on
the memory card in the camera.
1
Make sure the HP all-in-one is turned on and that the initialization process is
finished.
2 Connect your PictBridge-compatible digital camera to the camera port on the front
of your HP all-in-one using the USB cable supplied with your camera.
3 Turn on your camera and make sure it is in PictBridge mode.
Note When the camera is connected correctly, the status light next to the memory card
slots is illuminated. The status light blinks green when printing from the camera.
If the camera is not PictBridge-compliant or is not in PictBridge mode, the status
light blinks amber and an error message displays on your computer monitor (if
you have the HP all-in-one software installed). Disconnect the camera, correct
the problem on the camera and reconnect. For more information about
PictBridge camera port troubleshooting, see the onscreen Troubleshooting
Help that came with your HP Image Zone software.
After you successfully connect your PictBridge-compliant camera to the HP all-in-one,
you can print your photos. Make sure the size of the paper loaded in the HP all-in-one
matches the setting on your camera. If the paper size setting on your camera is set to
the default, the HP all-in-one uses the paper that is currently loaded in the input tray.
Refer to the user guide that came with your camera for detailed information on printing
from the camera.
User Guide 49
Memory
Card and PictBridge