HP Virtual Connect 4Gb Fibre Channel Module for c-Class BladeSystem - Manual (Page 5)

Introduction 5
Introduction
What's New
The command line interface user guide contains the following changes for VC 3.15:
• Support for the HP ProLiant BL620c G7 Server Blade
• Support for the HP ProLiant BL680c G7 Server Blade
• Support for HP Virtual Connect FlexFabric technology
• Support for the HP Virtual Connect FlexFabric 10Gb/24-Port Module
• New managed elements:
o fcoe-connection (on page 33 )
NOTE: HP Virtual Connect FlexFabric 10Gb/24-port Module FCoE support for HP Integrity
BL8x0c i2 Series Server Blades with HP NC551m FlexFabric Converged Network Adapters will
be available in the Virtual Connect 3.17 release.
The command line interface user guide contains the following changes for VC 3.10:
• Support for the HP Integrity BL8x0c i2 Series Servers
This server is a multi-blade server that has one bay identified as the monarch bay. All operations on the
multi-blade server are performed on the monarch bay, although operations such as power on or
assigning a profile affects the entire multi-blade server.
• Removed the update firmware command
To update firmware, use the HP BladeSystem c-Class Virtual Connect Support Utility. For more
information on installing the firmware, see the HP BladeSystem c-Class Virtual Connect Support Utility
documentation on the HP website ( http://www.hp.com/go/bladesystem/documentation ).
• New managed elements:
o iscsi-boot-param (on page 38 )
o iscsi-connection (on page 41 )
o link-dist-interval (on page 47 )
o statistics (on page 71 )
Changes from VC 3.10 to 3.15
Command Changes Virtual Connect 3.10 Virtual Connect 3.15
add fabric
set fabric
Support was added for
the HP VC FlexFabric
10Gb/24-Port
Module.
The HP VC FlexFabric
10Gb/24-Port Module
is present in the help
file, but it is not
supported.
For the HP VC FlexFabric
10Gb/24-Port Module,
port numbers 1,2,3 and
4 correspond to ports
x1,x2,x3 and x4,
respectively.
add fabric The HP VC FlexFabric The HP VC FlexFabric The HP 4Gb VC-FC