HP Integrity rx4610 Server - Manual (Page 45)

Chapter 4 Installing Mass Storage Devices
37
5. Grasp the bay by the Front Panel display housing and gently pull the drive
bay out of the chassis.
Figure 4-5. Hard Disk Bay
Installing the Hard Disk Bay
To install the Hard Disk Bay, complete the following steps:
1. Turn off the system by using the power on/off switch on the front of the
chassis and remove both AC power cords.
2. If the front bezel is not already removed, remove the bezel.
3. Align the Hard Disk Bay such that the connector side is facing into the
chassis and push the bay into the front of the chassis.
4. Ensure the drive bay seats into the front connector on the Power
Distribution Board (T-Docking Board).
5. Replace the four screws at the top and bottom of the bay.
6. Replace any disk drives into drive bay as required.
7. Replace the Front Bezel.