HP Integrity rx4610 Server - Manual (Page 84)

Chapter 7 Installing Accessory Boards
76
Figure 7-4. Accessing the Non-Hot Plug Boards
10. Release the plastic retaining mechanism (I/O Card Guide) that secures the
end of the board nearest the front of the chassis so that it will allow a board
to be inserted
11. Be sure that the rocker switch that secures the end of the board nearest the
rear of the chassis is in the open position. If not, press the center of the
rocker switch until it clicks open and then rotate the mechanism downward
from outside the chassis.
12. If you are adding a new board, remove the perforated rear panel cover in
the slot you’re using by pushing it out from inside the chassis.
NOTE Ensure you save the slot covers for use later to prevent EMI
interference. These slot covers make a better metal-to-metal
contact than previous slot cover designs.
13. Being careful not to touch the components or gold edge connectors on the
add-in board, remove it from its protective wrapper and place it
component-side up on a nonconductive, antistatic surface.
14. Record the serial number of the board in your equipment log. See
Appendix B for the equipment log.