HP Designjet 700 Printer series - Manual (Page 149)

Full menu mode
Default: Automatic
Device setup
Lang
7-7
Company confidential. Postillo/755CM User’s Guide Final Freeze Status:Frozen
This is the cyan on page 7-7 (seq: 147)
This is the black on page 7-7 (seq: 147)
Changing the Graphics Language Setting for a
Different Application
Your software application communicates with the printer by a graphics language.
The HP DesignJet 755CM printer supports:
PostScript
HP-GL/2
HP-GL (7586B)
HP RTL
With the printer’s default setting, called Automatic , it decides for itself which type
of file it is receiving – PostScript, HP-GL/2, HP-GL or RTL – and prints it. Unless
you want to change the scale of a PostScript print from the front panel (see page
4-13), or are troubleshooting any of the problems listed under Comments in the
table below, then do not change this default.
To Change the Graphics Language Setting
Graphics
language Comments
Automatic This should work successfully for most software applications.
PostScript This lets you change the scale of a PostScript print from the
front panel.
See page 4-13.
7586, HP-GL/2 This should work successfully for most CAD applications.
With this graphics language setting another parameter is
available: Terminator. Try changing this setting from Normal
(the default) to Special:
E if you are using an obsolete HP 7586 (pen plotter) driver,
and your prints are incomplete.
HP-GL/2 Try this setting:
E if you have experienced image position problems.
E
if you have experienced timing problems.
However, if you choose this setting, you don’t have access to
the Terminator option.
Reconfiguring Your Printer
Changing the Graphics Language Setting for a Different Application
RECONFIG.
7