HP Designjet 700 Printer series - Manual (Page 164)

9-8
Company confidential. Postillo/755CM User’s Guide Final Freeze Status:Frozen
This is the cyan on page 9-8 (seq: 162)
This is the black on page 9-8 (seq: 162)
Clearing a Media Jam
1 Switch OFF the printer, open the window and raise the media lever.
off
1867
Don’t touch the stainless steel strip that runs the length of the printer behind
the cartridge carriage; its edge is very sharp. Keep hair, jewelry, clothing,
and foreign objects away from the printer mechanisms.
When moving the cartridge carriage, touch only the black plastic parts.
2 Carefully move the cartridge carriage out of the way – if possible all the way to the
enclosed area on the left or the right. Which way you are able to move it depends
on where the media is jammed. If the printer was in the process of cutting media at
the time of the jam, the cutter carriage will be attached to the cartridge carriage and
will move with it.
3 Carefully remove any of the jammed media which you can easily lift up and out
from the top of the printer.
4 Carefully pull the rest of the roll or sheet down and out of the media entry slot.
5 Lower the window and the lever and switch on the printer. Press the Form Feed
and Cut key to eject any pieces of media that are still in the media path.
6 Reload the media as normal – see page 3-9. Remember that, if it’s a roll, you may
need to trim the edge.
Troubleshooting
Clearing a Media Jam
W A R N I N G