HP Designjet 700 Printer series - Manual (Page 20)

1-2
Company confidential. Postillo/755CM User’s Guide Final Freeze Status:Frozen
This is the cyan on page 1-2 (seq: 18)
This is the black on page 1-2 (seq: 18)
Fast Track
If You Meet All the Following Requirements:
You want English as the language of the front-panel display and of the printer’s
sample prints.
You are experienced at installing printers.
You are going to use roll media and print in color.
You know whether to connect the printer directly to your computer or to a
network and whether to use the serial or parallel interface, and you already have
the right cable.
(Serial interface users) Your computer’s RS-232-C settings are 9600 baud, no
parity, 8 data bits and 1 stop bit.
... Just Follow the Six Steps on this Page, and Skip the Rest of this Chapter.
1 Connect the power cord and switch on.
2 Load the roll of media supplied, following the instructions on the label inside
the printer’s roll cover. Watch the front-panel display for further
instructions.
3 Press Access Cartridges , open the printer’s window, remove the tape from
the four cartridges and load them into the carriage on the left side of the
printer.
4 Close the window and let the printer run its automatic cartridge-alignment
procedure.
5 Switch off the printer and your computer, connect the interface cable, and
then switch them on again.
6 Choose your driver disk(s) and color profile disk(s), read the instructions on
the label, and follow any printed instructions accompanying the disks. For
many Macintosh, Microsoft Windows or AutoCAD applications, the driver is
shipped with the printer. For other applications, see page 1-35 for advice,
and, if necessary, contact your software vendor.
That’s All!
Setting Up the Printer
Fast Track