HP XP RAID Manager Software - Manual (Page 111)

RAID Manager command reference 111
horcctl
Change and display RM internal trace and control parameters
Description
The horcctl command is used for maintenance (except for the –S, –D, –C,
–ND, –NC
, and –g arguments) and troubleshooting. When issued, the
internal trace control parameters of RM and RM commands are changed
and displayed.
If the arguments –l level, –b m, –s size(KB), or –t type are not specified, the
current trace control parameters are displayed.
Syntax
horcctl –h
horcctl { –b y/n
| –c | –d | –l level | –q | –s size(KB) | –t type | –z | –zx }
horcctl –S
horcctl { –D | –C | –u unitid }
horcctl { –ND | –NC | –g group
}
Arguments
–h Displays Help/Usage and version information.
–b y/n Sets a trace level.
y specifies buffered mode.
n specifies synchronous mode.
–c Interprets the trace control arguments (–l level, –b y/n,
–t type ) following this argument as parameters for the
CA manager.
–d Interprets the trace control arguments (–l level, –b y/n,
–s size(KB) , –t type) following this argument as
parameters for RM.
–l level Sets a trace level to the one specified in level.
The range is between 0 and 15.