HP XP RAID Manager Software - Manual (Page 208)

208 HP StorageWorks Disk Array XP RAID Manager: User’s Guide
This option can be used with the –fx option to display
the LDEV numbers in hexadecimal format.
–find conf [MU#] [–g name]
Used to display the port, target ID, and LUN in the
horcm.conf
file by using a special raw device file
provided via STDIN.
If the target ID and LUN are unknown for the target
device file, then you will have to start RM without a
description for HORCM_DEV and HORCM_INST.
This option allows you to use the –fx option to display
the LDEV numbers in hexadecimal format.
The –g name option is used to specify the name to be
used for dev_group in the horcm.conf file. If this
option is not specified, the group applies VG as the
default.
–find inst This option runs automatically at /etc/horcm_startup
time. It is used to logically connect and register a device
file name to all pertinent mirror descriptors [MU#s] in
the LDEV map table. It allows RM to note permitted
volumes.
Normally, the user does not need to run this command.
RM gets the serial# and LDEV# from the disk array.
Then, RM compares the inquiry result to the contents of
the Horcm.conf file, and the result is displayed and
stored within the RM instance. To minimize the time
required, this option is terminated when the registration
is finished based on the horcm.conf file.
This option can be used with the –fx option to display
the LDEV numbers in hexadecimal format.
If the –pi strings option is also specified, then this
option does not get its “strings” via STDIN. The strings
specified in the –pi option will, instead, be used as
input.