HP StorageWorks XP Remote Web Console Software - Manual (Page 163)

Connecting TagmaStore AMS and TagmaStore WMS
subsystems
System parameters for connecting TagmaStore AMS and TagmaStore WMS
subsystems
Table 16 explains whether to specify system parameters when making settings for ports on TagmaStore
AMS and TagmaStore WMS subsystems.
NOTE:
When connecting to a TagmaStore AMS or TagmaStore WMS subsystem, use XP LUN Configuration
and Security Manager Software to set the data transfer speed of the XP12000/XP10000/SVS200
external port you use to a fixed value other than Auto Negotiation. Also, set the data transfer speed
of the target port of the TagmaStore AMS or TagmaStore WMS subsystem to the same fixed value
according to the data transfer speed of the external port.
Table 16 System parameter settings (TagmaStore AMS and TagmaStore WMS subsystems)
Parameter setting Parameters Pane
name
Start Attribute
Boot Op-
tions
Specify this parameter when the TagmaStore AMS or TagmaStore
WMS subsystem is in the one-controller configuration.
• Single Mode
Specify this parameter when the TagmaStore AMS or TagmaStore
WMS subsystem is in the two-controller configuration.
• Dual Active Mode
You can either specify this parameter or omit specifying this
parameter.
Delay Planned Shutdown
You can either specify this parameter or omit specifying this
parameter.
Drive blocking mode
Keep this parameter as HITACHI (default), and do not change. Vendor ID
Keep this parameter as DF600F (default), and do not change. Product ID
You can either specify this parameter or omit specifying this
parameter.
ROM Microprogram Version
You can either specify this parameter or omit specifying this
parameter.
RAM Microprogram Version
You can either specify this parameter or omit specifying this
parameter.
Option
System
Paramet-
er
Set this parameter to Reset of occurred.
Operation if the processor fail-
ure occurs
You can either specify this parameter or omit specifying this
parameter.
WEB Title
XP External Storage Software User Guide 163