HP Photosmart Pro B8353 Printer - Manual (Page 35)

Installing the optional automatic two-sided printing
accessory (duplex unit)
The printer can automatically print on both sides of a sheet of paper when a duplex unit is attached to
the back of the printer.
NOTE The duplex unit is an optional accessory that is available for the HP Photosmart Pro
B8300 series printer. It may be purchased separately in some countries/regions (see HP supplies
and accessories .)
To install the duplex unit
1. Remove the rear access panel by pushing the release buttons toward each other.
2. Pull the rear access panel out of the printer.
3. Insert the duplex unit straight into the back of the printer until both sides snap into place.
NOTE Do not press the buttons on either side of the duplex unit when installing it. Use these
buttons only for removing the duplex unit from the printer.
ENWW Installing the optional automatic two-sided printing accessory (duplex unit) 25