HP StorageWorks XP Remote Web Console Software - Manual (Page 122)

Figure 80 FCWITHDR Command Description (DEVN Specified, ACTION = THAW) (for Case 7)
FCWITHDR DEVN(X'4202') ACTION(THAW)
Because no relationship is withdrawn by performing this command, there will be no change in the
number of relationships after using the command.
Even if you do not issue this command, the write operation to volumes may be resumed automatically
if the state-change-pending time elapses. For information about the state-change-pending time, see
“Establishing Version 2 Relationships while Suspending Write Operations to S-VOLs” (page 106) .
Releasing a Version 2 Relationship Using the ICKDSF Command
“Parameters for the ICKDSF Command in Version 2” (page 122) lists the parameters you can use
with the ICKDSF command when you release Version 2 relationships.
Table 60 Parameters for the ICKDSF Command in Version 2
Description Value Parameter Command
Specifies the JCL statement
identifying the volume. If the
OS of the host server is
MVS, this parameter or the
UNITADDRESS parameter is
required. JCL statement DDNAME or DNAME FLASHCPY WITHDRAW
Specifies the SYSNAME in
the ASSGN system control
statement. If the OS of the
host server is VSE, this
parameter is required. SYSNAME SYSNAME
Specifies the device number
(device address) of the
S-VOL on which you want to
perform the FLASHCPY
WITHDRAW
command. If the
OS of the host server is
MVS, this parameter or the
DDNAME parameter is
required.
Source device number UNITADDRESS, UNITADDR,
or UNIT
Specifies the CU number,
LDEV number, and device
number (device address) of
the T-VOL on which you
want to perform the
FLASHCPY WITHDRAW
command. This parameter is
required. CU number LDEV number
Target device number TARGETVOL or TGTVOL
122 Performing Version 2 Operations