HP PSC 1610v All-in-One Printer - Manual (Page 27)

Warning Legal paper might get caught on the paper tray extender if it is
fully extended when you print onto legal paper. To avoid a paper jam
when using legal-size paper, do not flip open the paper tray extender.
3. Squeeze and hold the tab on the top of the paper-width guide, then slide the
paper-width guide to its outermost position.
4. Tap a stack of paper on a flat surface to align the edges, and then check the
paper for the following:
–
Make sure it is free of rips, dust, wrinkles, and curled or bent edges.
– Make sure all the paper in the stack is the same size and type.
5. Insert the stack of paper into the paper tray with the short edge forward and the
print side down. Slide the stack of paper forward until it stops.
Tip If you are using letterhead, insert the top of the page first with the
print side down. For more help on loading full-size paper and letterhead,
refer to the diagram engraved in the base of the paper tray.
6. Squeeze and hold the tab on the top of the paper-width guide, then slide the
paper-width guide inward until it stops at the edge of the paper.
Do not overload the paper tray; make sure the stack of paper fits within the paper
tray and is no higher than the top of the paper-width guide.
Chapter 4
24 HP PSC 1600 All-in-One series
Load
originals
and
load
paper