HP PSC 1610v All-in-One Printer User Manual
Page 94
●
Plug the power cable into a grounded power outlet, surge protector, or power
strip. If you are using a power strip, make sure the power strip is on.
●
Test the power outlet to make sure it is working. Plug in an appliance that
you know works, and see if the appliance has power. If not, then there might
be a problem with the power outlet.
●
If you plugged the HP All-in-One into a switched outlet, make sure the switch
is on.
●
When you press the
On
button, wait a few seconds for the HP All-in-One to
turn on.
My USB cable is not connected
Solution
You must first install the software that came with your HP All-in-One
before connecting the USB cable. During installation, do not plug in the USB
cable until prompted by the onscreen instructions. Connecting the USB cable
before prompted can cause errors.
Connecting your computer to your HP All-in-One with a USB cable is
straightforward. Simply plug one end of the USB cable into the back of your
computer and the other into the back of the HP All-in-One. You can connect to
any USB port on the back of your computer.
Note
Do not plug the USB cable into the USB port on your keyboard.
User Guide
91
Troubleshooting
information