HP PSC 1610v All-in-One Printer - Manual (Page 99)

● Make sure your computer is USB ready. Some operating systems, such as
Windows 95 and Windows NT, do not support USB connections. Check the
documentation that came with your operating system for more information.
● Check the connection from your HP All-in-One to your computer. Verify that
the USB cable is securely plugged into the USB port on the back of your
HP All-in-One. Make sure the other end of the USB cable is plugged into a
USB port on your computer. After the cable is connected properly, turn your
HP All-in-One off and then on again.
● If you are using a Macintosh: Check the Apple System Profiler (OS 9) or the
System Profiler (OS X) to verify your USB connection. If the HP All-in-One
shows up in the USB window, then the USB connection between your
computer and HP All-in-One is working. If it is working, there might be a
problem with the software. Try to run the HP All-in-One Setup Assistant to
see if it can detect the HP All-in-One. (You can access the HP All-in-One
Setup Assistant through the HP Image Zone software.)
● Check other printers or scanners. You might need to disconnect older
products from your computer.
● Try connecting the USB cable to another USB port on your computer. After
you check the connections, try restarting your computer. Turn your HP All-in-
One off and then on again.
● After you check the connections, try restarting your computer. Turn your
HP All-in-One off and then on again.
For more information on setting up your HP All-in-One and connecting it to your
computer, see the Setup Guide that came with your HP All-in-One.
I received a message on the control panel display about a paper jam or a
blocked carriage
Cause There might be some packing material inside the HP All-in-One or a
paper jam.
Solution Lift open the print-carriage access door to expose the print cartridges
and remove any packing material, tape, or other foreign objects. Turn off the
Chapter 13
96 HP PSC 1600 All-in-One series
Troubleshooting
information