HP XP Racks - Manual (Page 87)

In this case, two different logical volumes with the same name (LUN 1 and LUN 2) are found that
can be connected from EVA Port A. But you cannot determine which LUN 1 and LUN 2 belong to
HostGroup-1 or HostGroup-2 only by Characteristic1.
However, in Remote Web Console, you can identify the logical volumes referring to Characteristic2.
The first 32 characters of Characteristic2 indicate the World Wide LUN Name. Identify the logical
volume of the EVA storage system by this World Wide LUN Name.
Sun StorEdge 6120/6320
System Option Mode for connecting Sun StorEdge 6120/6320
When you connect Sun StorEdge 6120/6320 as an external storage system, you must set SOM
725 of the local storage system to ON. If SOM 725 is not set to ON, the external storage system
might be blocked when performing maintenance tasks such as rebooting the controller of the
external storage system before the firmware update.
For worldwide technical support information, see the HP support website:
http://www.hp.com/
support .
System option parameters for connecting Sun StorEdge 6120/6320
The port must be configured as a target attached to a Windows host.
Set system parameters according to the following table. For connection parameters not shown,
refer to the Sun StorEdge 6120/6320 system documentation.
On the local HP XP7 Storage, set system option mode 725 to ON for support of Sun online
maintenance operation.
Parameter Setting Parameter
SUN port host
Sun StorageTek FlexLine 380
System Option Mode for connecting Sun StorageTek FlexLine 380
When you connect Sun StorageTek FlexLine 380 as an external storage system, you must set SOM
725 of the local storage system to ON. If SOM 725 is not set to ON, the external storage system
might be blocked when performing maintenance tasks such as rebooting the controller of the
external storage system before the firmware update.
For worldwide technical support information, see the HP support website:
http://www.hp.com/
support .
Sun StorEdge 6120/6320 87