HP ESL E-series Tape Libraries - Manual (Page 137)

Message name / description ASCQ ASC Sense
key
TRANSFER FULL - AT END OF PLACE
Picker has cartridge in it at end of a place operation (Move Medium with
a target other than the Transfer).
• Move cartridge to empty storage element using your application
software. Retry command.
• As a last resort, manually remove the tape from the robotics.
01 80 B
TRANSFER EMPTY - COMMAND ABORTED
Picker does not contain cartridge at end of pick portion of the Move
Medium command. 06 80 B
LOAD RETRY FAILED
Library was unable to successfully load and thread the drive, even after
retries.
• Check drive alignment.
• Make sure the correct media for the drive is being used.
• If cartridge loads in another drive successfully, the original drive may
have failed.
10 80 B
COMMAND ABORTED BY USER
Informational message. No action is necessary. 0B 80 B
CARTRIDGE PARTIALLY GRIPPED
• Issue a Move Medium command using your application software to
move the cartridge from the transfer element to an empty storage
element.
• If necessary, manually clear the media, recalibrate, then inventory
the library.
0D 80 B
TRANSPORT FULL
The CLM contains a cartridge. Issue a command to retrieve the cartridge
from the CLM and place it in either a bin or a tape drive. C0 88 B
LOAD PORT LATCH FAILURE
The load port door was unlocked, but did not leave its current position
before time-out (30 seconds). This may be due to the door being stuck,
or in the case of a close operation, the operator not moving the door. 01 8C B
LIBRARY UNIT COMMAND TIMED OUT
Verify that communications to library still exists by issuing another
command. 00 8F B
CLEANING CARTRIDGE INSTALLED
Indicates that the element contains a cleaning cartridge that is not
“used-up.” This is returned with the element status data, which has no
sense key. 03 30 -none-
HP StorageWorks ESL E-Series Tape Library 137