HP ESL E-series Tape Libraries - Manual (Page 73)

3 Maintenance and troubleshooting
This chapter describes problems you may encounter during the setup and operation of the library.
Corrective information is provided to help you resolve the problems. The information is organized
into:
• Start-up problems
• OCP problems
• Robotics problems
• Operating problems
• Switch problems
• Tape drive problems
• Interface Manager card problems
• FC interface controller problems
• Maintaining tape cartridges
• Cleaning tape drives
NOTE:
Also see Sense data values for information on values appearing in library error codes and the
error log.
NOTE:
For additional assistance with troubleshooting, use the online HP Guided Troubleshooting tool which
can be found at
http://h20499.www2.hp.com/gts/sparks/public/Admin_Navigate_All_All_All .
Start-up problems
This section describes corrective actions for problems which occur during start-up.
The library does not power on
Verify that:
• The power cord is connected to a grounded electrical outlet.
• The power distribution unit's two breaker switches are on (left rear corner of cabinet).
• The power supply switches are on.
• The power switch behind the service tray is on. (Your library might not have a service tray.)
HP StorageWorks ESL E-Series Tape Library 73