HP Designjet Z3100 Photo Printer series - Manual (Page 130)

9. Close transparent window.
10. Switch on the printer.
11. Reload the roll, or load a new sheet. See Load a roll into the printer on page 27 or Load a single
sheet on page 31 .
NOTE If you find that there is still some paper causing an obstruction within the printer, restart
the procedure and carefully remove all pieces of paper.
Prints do not fall nicely into the basket
● Ensure the basket is correctly installed.
● Ensure the basket is open.
● Ensure the basket not full.
● Paper often tends to curl near the end of a roll, which can cause output problems. Load a new roll,
or remove prints manually as they are completed.
The sheet stays in the printer when the print has been
completed
The printer holds the paper to allow the print to dry after printing, see Change the drying time
on page 38 . If the paper is only partially ejected after the drying time, gently pull the sheet out of the
printer. If the automatic cutter is disabled, use the Form feed and cut key on the front panel, see Feed
and cut the paper on page 39 .
The paper is cut when the print has been completed
By default the printer cuts the paper after the drying time has been completed, see Change the drying
time on page 38 . You can disable the cutter, see Turn the automatic cutter on and off on page 38 .
120 Chapter 11 Troubleshooting paper issues ENWW
Troubleshooting paper
issues