HP PCIe IO Accelerators for ProLiant Servers - Manual (Page 111)

Using Windows page files with the IO Accelerator 111
page 109 )" to properly enable page file support on one or more IO Accelerators.
System drive paging file configuration
By default, Windows® operating systems create and manage a page file on the system boot drive
(typically a hard disk), which is where the operating system is installed. Maintaining a regular page file
on the system hard disk is typically not optimal, because the hard disk I/O performance is many orders of
magnitude slower than an IO Accelerator. To resolve this issue, you can eliminate or minimize the size of
the system boot drive page file, as explained later. Enabling page files on IO Accelerators but not the
system drive improves VM subsystem performance since the VM manager stripes I/O across all available
page files. Additionally, the IO Accelerators act as a large memory store, which can greatly improve
memory usage for large applications.
The Windows® kernel uses the system disk page file to store crash dumps. Crash dumps might be small
(mini-dumps) or large (full-kernel memory dumps). Typically, running without dump file support or with a
small dump file is adequate. There are several possible system drive page file configurations:
• Eliminate all page files on any hard disks, including the system boot drive. Although this maximizes
paging I/O on IO Accelerators, no post-mortem crash dump file will be available if a system crash
occurs. However, you might be able to re-enable a page file on the system drive and then reproduce
the crash scenario.
• Create a minimal-size page file on the system boot drive. The recommended minimum size is 16MB,
although the operating system might warn that a minimum 400MB page file is needed.
• Create a page file large enough for a full-kernel memory dump. This typically requires a page file at
least the size of installed RAM, with some recommending the size equal to RAM x 1.5.
To view or change the crash dump configuration:
1. Go to the System Properties dialog box.
2. Click the Advanced tab.
3. In the Startup and Recovery section, click Settings. The Startup and Recovery dialog box opens.
4. In the System Failure section, you can change settings to handle the system log, restart, and
debugging information.
Guaranteeing minimum commitable memory
If you enable System managed size or set a Custom size in the Virtual Memory dialog box, do so with
care. If the initial size is less than the desired amount of committable virtual memory, this size might cause
an application to have memory allocation failures if the amount of committed memory exceeds the
currently allocated page file size or the initial size value. When committed memory exceeds the current
page file size, a request to allocate additional memory will fail. The Windows® Virtual Memory manager
will slowly increase the size of the paging file up to the available size of its drive or to the Maximum size
custom setting, whichever is smaller.
If you want to use a large amount of committed virtual memory (more than 1.5 times the amount of RAM)
and avoid application memory allocation errors, the initial and maximum committed memory must be
explicitly set for the expected application committed memory usage. These values should generally be the
same.
The following articles explain in detail how to size the page file appropriately.