HP PCIe IO Accelerators for ProLiant Servers - Manual (Page 99)

Utilities 99
• -a: Prints all available information for each device. The following information is reported:
o Number and types of boards installed in the system
o Attach status
o Serial number
o Part number
o Manufacturer's code
o Manufacturing date
o Firmware version
o Size of the device, out of total capacity
o Low-level format GUID
o PCIe information, including the bus ID, vendor ID, device ID, and PCI slot number
o Internal temperature (average and maximum, since driver load) in degrees Celsius
o Board temperature, in degrees Celcius
o Internal voltage, average and maximum
o Auxiliary voltage, average and maximum
o Health status: healthy, nearing wear-out, write-reduced or read-only
o Percentage of good blocks
Basic Information: If no options are used with the fio-status utility, the following basic information is
reported:
• Number and type of boards installed in the system
• Attach status
• Product name
• Product number
• Firmware version
• Size of the device, out of total capacity
• Internal temperature (average and maximum since driver load) in degrees Celcius
• Health status: Healthy, nearing wear-out, write-reduced or read-only
Data Volume Information: If the -d option is used, the following basic information is reported in addition
to the basic information:
• Physical bytes written
• Physical bytes read
Error Mode Information: If the driver is in minimal mode, read-only mode, or write-reduced mode when
the fio-status utility is run, the following differences occur in the output:
• Attach status is Status unknown: Driver is in MINIMAL MODE.
• The reason for the minimal mode state displays (such as Firmware is out of date. Update
firmware.)
• Geometry and capacity information not available appears.
• No media health information displays.