Ag Leader EZ-Guide 500 Getting Started Guide - Manual (Page 32)

You can change two settings for the Headland pattern:
The number of circuits
•
The internal pattern (in Advanced mode only)
•
Number of circuits
When you create a headland, you need to specify the total number of circuits (including the master
headland). This defines how wide the headland is.
Note: No matter how many circuits you are creating, you only define the outside headland. The inner
headlands circuits are copied from that original circuit.
Internal pattern
The internal pattern is the pattern of the guidance lines inside the headland. In Easy mode, the internal
pattern is automatically an AB Line. In Advanced mode, there is a choice of two internal pattern types:
ITEM DESCRIPTION
Straight AB Creates standard parallel swaths inside a headland
A+ Creates parallel swaths at a pre−defined heading
Ending the headland
Note: You need to define the master line for the internal pattern before you complete the headland.
To finish defining the headland, do one of the following:
28