Flex-a-Lite 4110M4 Ford Mustang 1997-2004 Transmission Oil Cooler Kit - Manual

1
#4110M4 Ford Mustang 1997-2004 Transmission
Oil Cooler Kit
Fits MOST Ford Mustangs, 1997-2004
(Note: Vehicle models may vary; review the instructions and
components for compatibility with your vehicle prior to
installation.)
Assemble Cooler Kit
1. Place GatorClips® around copper tubes of cooler.
2. Put washer and bolt through GatorClips®
3. With cooler inlets facing toward the right, position
brackets onto bolts so they angle down and the top
mounting tabs are bent toward the outside of the cooler.
(Fig. 1)
4. Place nut and washer on end of each bolt and tighten
full assembly together.
Mount Cooler To Vehicle
1. Locate factory power steering cooler between bumper
and AC condenser.
2. Unbolt two bolts holding factory brackets.
3. Slide cooler bracket feet behind factory brackets and
bolt with supplied hardware. (Fig. 2)
98184 Rev. 02-03-14
2
Attach Factory Transmission Lines
1. Cut factory transmission line. DO NOT CRUSH LINE
2. Double flare cut factory lines.
3. Attach supplied hoses to cooler fittings with hose
clamps.
4. route hoses through drivers side to factory flared
transmission lines. Attach and secure lines with zip ties
and remaining hose clamps.
5. Top off and purge transmission fluid of all air and test.
3
4
What’s Next?
Register your product for warranty at
http://automotive.flex-a-lite.com/warranty-registration/
Enjoy your Flex-a-lite performance cooling product!
If you need further assistance, please contact tech services
at 253-922-2700 M-F 8:00am-5:00pm PST.
The Flex-a-lite Limited Warranty
Flex-a-lite Consolidated, 7213-45th St. Ct. E. Fife, WA 98424, Telephone No. 253-922-2700, warrants to the original purchasing
user, that all Flex-a-lite products to be free of defects in material and workmanship for a period of 365 days (1 year) from date of
purchase. Flex-a-lite products failing within 365 days (1 year) from date of purchase may be returned to the factory through the
point of purchase, transportation charges prepaid. If, on inspection, cause of failure is determined to be defective material or
workmanship and not by misuse, accidental or improper installation, Flex-a-lite will replace the fan free of charge,
transportation prepaid. Flex-a-lite will not be liable for incidental, progressive or consequential damages. Some states do not
allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to
you. This warranty gives you specific legal rights and you may have other rights, which vary from state to state.
The Flex-a-lite warranty is in compliance with the Magnuson-Moss Warranty Act of 1975.
Fig. 1
Cooler Shown with optional guard kit #4110G
Fig. 2