Flex-a-Lite 4116C COOLER KIT - CAMARO 2010-2011 - Manual

COOLER KIT - CAMARO 2010-2011
Part #4116C
“Direct fit” auxiliary transmission cooler
INSTALLATION INSTRUCTIONS
BE SURE THE ENGINE IS COOL BEFORE PROCEEDING!
After the radiator has been removed, disconnect 1.
the short sections of flexible hose (2ea) from the
metal transmission cooling lines.
(see Detail A)
Cap the ends of metal transmission cooling lines to
prevent transmission fluid from leaking.
Loosen metal bezel just above hood latch by 2.
removing adjustable hood stops (2ea), plastic
push-in fasteners (6ea) and bolts 10mm (4ea).
Loosen bolts 13mm (2ea) attaching hood latch
mechanism to radiator support and allow latch to
move downward. Gently pull out metal bezel from
under plastic lip being careful not to catch on hood
latch release lever.
(see Detail B on next page)
Finish removing bolts attaching hood latch.
(see Detail C on next page)
Attached to the hood latch is an electrical 3.
connector. Unplug connector and move hood latch
out of the way.
Reach down into the space that the cooler will be 4.
mounted into and remove the large plastic push-in
fasteners (2ea) at the bottom securing the plastic
cowling bottom.
Rev. 02-13-12 98116 Page 1 of 4
Cooler ........................................ 1 ea.
Top Bracket (small) .................... 1 ea.
Bottom Bracket (large) ............... 1 ea.
Channel ..................................... 2ea.
Rubber Hose @ 4ft .................... 2ea.
Instruction Sheet ....................... 1 ea.
Warranty Card ........................... 1 ea.
Flex-a-lite Decal ......................... 1 ea.
*Hardware Kit ............................ 1 ea.
* Hardware Kit Includes:
bolt hex head 5/16-18 x 1-1/2” (2ea)
bolt hex head M8-1.25 x 30mm (2ea)
bolt hex head 1/4-20 x 1-1/2” (4ea)
cap screw socket head 1/4-20 x 3/4” (4ea)
u-nut 5/16-18 (2ea)
nut nylock 1/4-20 (4ea)
lock washer 5/16” I.D. (4ea)
lock washer 1/4” I.D. (4ea)
plastic spacer, large .375” thick (4ea)
gatorclip 1/2” (8ea)
worm drive hose clamp (4ea)
nylon tie straps (4ea) Note: Always read instructions
and verify kit contents prior to
installation.
We recommend installing the transmission cooler kit when the radiator has been
removed from the vehicle. The additional room allows for easier access to the tight
space where the cooler is to be installed.
Instructions for removal of the Camaro 2010-2011 stock radiator can be downloaded.
Visit www.flex-a-lite.com and download the PDF for the Camaro radiator & fan kit #56488.
Detail A
Remove short sections of
flexable transmission coolant lines
Note: May not fit with some aftermarket superchargers.