Flex-a-Lite 345 Nissan 240SX Fits 1989-1998 - Manual

345
Nissan 240SX
Fits 1989-1998
INSTALLATION INSTRUCTIONS
Remove the lower engine splash shield. This will allow you to easily ac-
cess the radiator drain valve and the lower fan shroud.
Drain the coolant from the radiator. Use a clean drain pan and set it in a
clean spot so that the coolant can be reused (see Detail 1)
Remove the air intake tube. It’s easiest to disconnect it at the connec-
tion to the air flow sensor block (see Detail 2).
Remove the radiator inlet hose and tie it back out of the way.
Remove the 2 bolts holding the lower portion of the fan shroud in place.
Remove the 2 clips holding the fan shroud ring in place.
Remove the bolt securing the air intake resonator/silencer located at the
bottom of the fan shroud.
Remove the hose and wire clips from the top of the fan shrou
Unplug the A/C fan wire harness (see Detail 3). This harness will be
used later when wiring the fan control unit. Remove and save the 2
bolts that attach the top of the A/C fan and the top of the shroud. These
will be used later to attach the new electric fan assembly. The factory
A/C fan will not be used and can be removed.
1.
2.
3.
4.
5.
6.
7.
8.
9.
NOTE: FOLLOW ALL INSTRUCTIONS CAREFULLY TO AVOID PERSONAL INJURY AND
DAMAGE TO THE FAN, CONTROL MODULE, AND YOUR VEHICLE!
Detail 1
Detail 2 Detail 3 Detail 4
The resonator/silencer box
can’t be used with this kit.
Page 1 of 4 #98345 Rev. 05-17-10
Pull back the wires and hoses that run over the top of the shroud, then remove the top half of the shroud.
Remove the air resonator box. NOTE: The air resonator/silencer can’t be used with this electric fan.
Plug the hole in the air intake tube before reinstalling it to ensure no dirt or moisture enters the intake
tract (see Detail 4). Use the rubber cap included and secure it with a zip tie or hose clamp.
Remove the clutch fan. Replace the flange nuts that held the clutch fan on as these also hold the pulley onto
the water pump.
Remove the lower half of the shroud and ring.
1.
2.
3.
4.