Flex-a-Lite 345 Nissan 240SX Fits 1989-1998 - Manual (Page 4)

Find the temperature probe attached to the control unit. Insert the temp. probe through the hole in the top
bracket that is directly below the radiator inlet hose. Gently push the probe through the radiator fins. Push the
rubber cap over the end of the temp. probe to insulate it. You may have to loosen the top radiator bracket to
install the rubber cap. Zip-tie loose wires and vacuum lines to to the top bracket to keep them clear of the fan
blades.
Connect the radiator hose and refill the radiator with coolant. Be sure to remove the air bleed bolt before refill-
ing (located where the top radiator hose connects to the engine). Reinstall the air bleed bolt, the lower engine
cover, and the air intake tube. Insert the fuse for the electric fan into the fuse holder and reconnect the battery
terminals.
Start the engine and allow it to warm up completely. It is best to use a digital thermocouple or infrared heat
gun to read the temperature as the vehicle’s temperature gauge is not accurate enough. Feel the top radiator
hose - there should be hot coolant flowing through it. The engine is completely warmed up when it reaches
about 185° F.
If the fans have not already cycled on, turn the temperature control knob counterclockwise just until the fans
come on. The fans should cycle on and off to keep your engine at this temperature.
Turn on the air conditioning. The fans should cycle on and off with the A/C compressor. If not, check to see
that the A/C signal wire is connected correctly.
6.
7.
1.
2.
3.
CONTINUED FROM PREVIOUS PAGE
WIRING DIAGRAM
Initial Start-up and Adjustment Procedure
The Flex-a-lite Limited Warranty
Flex-a-lite Consolidated, 7213-45th St. Ct. E., Fife, WA 98424, Telephone No. 253-922-2700, warrants to the original purchasing user, that all Flex-a-lite products to be free of defects in material
and workmanship for a period of 365 days (1 year) from date of purchase. Flex-a-lite products failing within 365 days (1 year) from date of purchase may be returned to the factory through the
point of purchase, transportation charges prepaid. If, on inspection, cause of failure is determined to be defective material or workmanship and not by misuse, accidental or improper installation,
Flex-a-lite will replace the fan free of charge, transportation prepaid. Flex-a-lite will not be liable for incidental, progressive or consequential damages. Some states do not allow the exclusion
or limitaion of incidental or consequential damages, so the above limitation or exclusion may not apply to you. This warranty gives you specific legal rights and you may have other rights, which
vary from state to state. The Flex-a-lite warranty is in compliance with the Magnuson-Moss Warranty Act of 1975.
Page 4 of 4 #98345 Rev. 05-17-10