Innovate Motorsports MTX-D, Oil Temperature/Pressure Gauge - Manual (Page 3)

- 3 -
1 Mounting and Sensor Installation
1.1 Mounting the Gauge
The MTX Oil Temperature/Pressure gauge fits in a standard 2-1/16” (52mm) hole. The gauge
can be mounted into a commercially available 2-1/16” (52mm) gauge pod or by drilling a 2-1/16”
(52mm) diameter hole to your desired mounting location. Check behind he mounting location for
any wiring or components before drilling. Allow at least 2-1/4” (57mm) of depth for the gauge
body and associated wiring. Mounting of the gauge should be done in such a manner that the
cables are not being forcefully pulled from the gauge body itself.
The MTX Oil Temperature/Pressure gauge is splash resistant (not water proof) and can be
mounted so that it is exposed to the elements. The MTX gauge should not be submerged and
special consideration should be taken to protect the gauge from direct water spray (water coming
from a pressurized source.) When replacing the bezel and/or gauge face verify that the o-ring is
properly seated.
Make sure the mounting location does not impair visibility or interfere with driving.
1.2 Oil Temp Sensor
 The oil temp sensor provided in the kit has 1/8 PT external threads.
 Mount the sensor using Teflon tape over the threads to avoid oil leaks.
 Be sure the sensor wire is not twisted. Having the wire twisted will damage the sensor.
 Avoid bending the sensor wire near the sensor body.
1.3 Oil Pressure Sensor
 The oil pressure sensor provided in the kit has 1/8 PT external threads.
 Mount the sensor using Teflon tape over the threads to avoid oil leaks.
 Do not install the sensor near the oil pump or to the pressure switch directly. Failure to do
so could damage the sensor due to the pressure pulsations.
2 Wiring