Innovate Motorsports MTX-D, Oil Temperature/Pressure Gauge User Manual
Page 6
- 6 -
1. The
Display In will allow the gauge to display the temperature in either Imperial or Metric
unit of measure.
2. The Low Oil Pressure Alarm will enable the gauge’s seven segment to flash when the
entered threshold value has been exceeded. To enable this feature the “Enable” option
must be checked.
3.5
Temp Tab
1. The
Display In will allow the gauge to display the temperature in either Imperial or Metric
unit of measure.
2. Outer LED Display: You are able to select between Bar or Dot.
Bar allows the gauge’s outer LEDs to flash incrementally.
Dot
allows the gauge’s outer LEDs to flash each individual LED color (virtual needle.)
The Needle Ranges allows the configuration of each outer LED segment. The range
displayed is user defined.
3. The Oil Temperature Alarm will enable the gauge’s outer LEDs to flash when the
entered threshold value has been exceeded. To enable this feature the “Enable” option
must be checked.
3.6
Updating the Firmware
The LM Programmer Info tab reports the firmware version currently installed on your unit. Do not
update the firmware if the versions are the same. A firmware update should only be
necessary if there has been a new release that specifically fixes a problem that you are
experiencing with the unit.
Firmware for the MTX Oil Temperature/Pressure gauge has the extension dld. New firmware
releases are available for download on the Innovate Motorsports’ web site
(www.tuneyourengine.com) under ‘Support.’