Innovate Motorsports MTX-L - Manual (Page 9)

9
3.1 Installing software
1. Double click on the Logworks 3 installer previously downloaded.
2. The installer will start, follow the prompts to install the software.
3. Once the software has been installed the LogWorks software, LM
Programmer and MTX-L manual can then be located by navigating
through Start->Programs->LogWorks3.
3.2 Connecting to LM Programmer
LM Programmer is used to update firmware, change fuel types, and program
the two analog outputs.
1. Connect the OUT port of the MTX-L to the provided serial
programming cable. Connect the other end of the serial
programming cable to your computer. If your computer does not
have a serial port, you can purchase a USB to Serial adapter from
Innovate Motorsports (P/N 3733) or use any USB to serial adaptor
that includes drivers. Make sure that nothing is connected to the IN
port of the MTX-L
2. Power up the MTX-L.
3. Launch LM Programmer. The LM Programmer application can be
launched from Start->Programs->LogWorks3->LM Programmer from
the Windows task bar.
3.2.1 Analog Outputs
1. Connect the MTX-L to the computer and launch LM Programmer.
2. Select one of the Analog output tabs. The Analog output tab looks
like this: