Innovate Motorsports DL-32 - Manual (Page 13)

- 13 -
on a flat, horizontal, surface and press and hold all three buttons together until the display shows
the letter ‘A’:
After this, re-try the above calibration procedure.
You can now mount the DL-32.
6. Setting up the input channels
The DL-32 can be programmed directly through the setup buttons on the DL-32. Alternatively, the
LM Programmer software version 3.09 (or later) allows you to program the DL-32 via the LM
Programmer software. This is necessary for some of the more advanced functionality of the DL-
32. Some of these advanced functions like speed sensing, frequency sensing, custom RPM, and
so on require more user input data that cannot be supplied by the simple 3-button interface of the
DL-32. The DL-32 must be programmed before it is introduced in the serial chain; the serial
IN port needs the terminator plug and the serial OUT is connected directly to the PC.
6.1 Programming the DL-32 with the setup buttons
To program an input channel, repeatedly press the ‘Channel’ button until the channel number to
program appears on the DL-32 digit display. Then repeatedly press the ‘Function’ button until the
digit display shows the intended function. The digit display will switch rapidly between indicating
the input channel number and the set function. The LEDs next to the channel and function
buttons will indicate which value is being displayed.
If the function selected is External input, the digit display shows a ‘=’ sign like this:
Each of the five inputs of the DL-32 can be user configured for different functionalities.
The 7-segment display of the DL-32 (Function indicator) will show which functionality is selected.
The following tables show the functionality of each of the 5 inputs of the DL-32:
Input 1 Functions
Function
Indicator 1 2 =
Functionality RPM
(0..10230)
RPM
(0..20460) External 0..5V
sensors
Input 2 Functions
Function
Indicator 1 2 3 4 5 =
Functionality Thermocouple
EGT range
(0..1093 degC,
32..1999 degF)
Thermocouple
CHT range
(0..300 degC,
32..572 degF) Side
Force
(+- 2g ) Side
Force
(+- 1g) Side
Force
(+- 0.25g) External 0..5V
sensors
Input 3 Functions
Function
Indicator 1 2 F =
Functionality Duty Cycle N/A Frequency (straight frequency,
Speed sensor, Custom RPM
range External 0..5V
sensors