Innovate Motorsports DL-32 - Manual (Page 27)

- 27 -
Select if you use a drive-shaft sensor or a wheel sensor. Enter the pulses per rotation created by
the sensor either as driveshaft rotation or wheel rotation. You also need to enter the wheel
diameter, and in case of a drive-shaft sensor, the final drive (differential) ratio.
The LM-Programmer will calculate the pulses per mile (km) for you.
This functionality is also available for Inputs 4 and 5.
13.6 Input 4 configuration
Function 1,2,3 and 4 on this input are used for pressure measurement. See chapter 7 for details.
For Custom Frequency, Custom RPM, speed sensing and duty cycle inputs on Input 4, see
chapter 12.5
13.7 Input 5 Configuration
For Custom Frequency, Custom RPM, speed sensing and duty cycle inputs on Input 5, see
chapter 12.5
When selecting one of the acceleration measurement modes for Input 5, the center of the window
changes to this:
Select the travel direction of the car. Please note that changing this setting will effect the travel
direction setting for side force measurements on Input 2 as well.