Installing the cab controller – Yetter 2940 Short Floating Air Adjust Residue Manager User Manual
Page 15
15
INSTALLING THE CAB CONTROLLER
Step 1: Begin installing the 2940 Air Adjust controller once an adequate mounting
location has been found, fix the base component of the 2940-113 Mounting Bracket in
place. Connect the mount bracket to the rear of the controller.
Step 2: Attach the male end 2 pin connector of the 2940-153 to the female end 2 pin
connector on the 2940-100 cab controller. Install connector not provided for your tractor
at the bare end of the 2940-153 and connect to tractors switched power source.
The
cigarette outlet is NOT a switched port on all models of tractors, and therefore
should not be used.
Convenience port connector part #’s:
JOHN DEERE PART #: RE67013
CNH PART #: 187103A1
Step 3: Route the 2940-152 hitch to switch panel
wire harness from the rear 6 pin connector of the 2940-100
cab controller to the hitch-point at the rear of the
tractor.