Yetter 2940 Short Floating Air Adjust Residue Manager - Manual (Page 63)

63
MAINTENANCE/ASSEMBLY
Lubrication Symbols
Lubricate with grease at hourly interval indicated on symbol.
Lubrication Intervals
IMPORTANT: The recommended service intervals are based on normal conditions; IMPORTANT: The recommended service intervals are based on normal conditions; IMPORTANT: The recommended service intervals are based on normal conditions; IMPORTANT: The recommended service intervals are based on normal conditions;
severe or unusual conditions may require mor severe or unusual conditions may require mor severe or unusual conditions may require mor severe or unusual conditions may require more frequent lubrication. e frequent lubrication. e frequent lubrication. e frequent lubrication.
Perform each lubrication and service procedure at the beginning and end of each season.
Clean grease fittings before using grease gun, to avoid injecting dirt and grit into the
bearing.
Replace any lost or broken fittings immediately. If a fitting fails to take grease, remove
and clean thoroughly, replace fitting if necessary. Also check for failure of adjoining parts.
BEARING REPLACEMENT INSTALLATION
1. When assembling the spoke wheels, bearing assembly and hubcap, be sure to
align the grease transfer hole in the spoke wheel with the groove in the hubcap
and hole in the hub to allow grease passage.
2. Assemble the wheels, hubs and caps.
3. Grease the wheel/hub/bearing assembly.