GReddy TURBO KITS: VW Golf 1.8T 2002-05 / TD04-19T - Manual (Page 13)

(8) Install the factory drive shaft heat shield.
※ Use factory bolts.
※ Please check to make sure there is clearance
around the heat shield after installing.
3 – 6 Airinx and Suction Pipe Installation
(1) Install the ５０φ－６０φsilicone reducer hose
onto the turbo side of the suction pipe and
use a hose clamp to attach.
※ Remove the O-ring that is on the suction pipe.
※ Wrap the silicone hose with the provided
thermo cloth.
〈Parts № 26, 33, 34, 43〉
Fires may be caused from parts that
are not protected from extreme heat.
(2) Install the Airinx air pump adapter and
adapter hose onto the Airinx air filter
housing.
※ Take caution when installing the air pump
adapter. Do not cross thread.
〈Parts № 5, 6, 46〉
(3) Remove the one of the bolts on the back of
the Airinx housing.
(4) Install the Air flow meter onto the Airinx filter.
Install the 70-80 reducer onto the Air flow
meter and place the Airinx Adapter Pipe inside
the opposite end of the reducer. Install
whole assembly onto factory suction hose.
Connect the air pump feed hose to air pump
adapter on Airinx housing. Connect the Air
Flow Meter harness connector.
〈Parts № 7, 8, 27, 35, 36〉
※ Use factor hose band on factor suction hose.
※ Take caution as air flow meter is directional.
12