GReddy TURBO KITS: VW Golf 1.8T 2002-05 / TD04-19T - Manual (Page 9)

3 - 3 Turbo Installation
(1) Place the included O ring where the suction
tube connects to the turbo inlet and use
provided bolt to install suction tube to turbo.
〈Parts № 1, 4, 50〉
(2) Install the banjo fitting to the turbo using the
provided banjo bolt and brass washer gaskets.
Install the oil pressure feed hose to the banjo
fitting.
※ Place the banjo fitting to direct the hose
toward the actuator waste gate.
〈Parts № 10, 11, 14〉
(3) Install four 8x30mm stud bolts onto the turbine
adapter and place a gasket on the flange.
Install onto the inlet side of the exhaust
housing.
Turbine side
※ Be careful to install studs on the proper side
of the flange. Use the picture to the right and
below.
〈Parts № 2, 39, 51 〉
8