Videoswitch Vi-K3 - Manual (Page 15)

Vi-K2/Vi-K3 Universal
Keyboard
Vi-K2 Universal Keyboard User Manual
13
• Press
the
OK key if you want this Vi-K2/Vi-K3 to be able to select cameras on this display. Press
the
BACK key if you do not want this Vi-K2/Vi-K3 to be able to select cameras on this display.
Note the LED display indicates the selected display and whether it is enabled for camera selection, for
example: “
D1.y” means that the main display monitor can be controlled, whereas “D2.n” would mean that
the spot monitor cannot be controlled.
2.2.7 Changing the Password
A new password may be set as follows:
• Make sure that you are in Configuration Mode as detailed in section 2.2.2.
• Holding
the
ALT key, press the 11 key.
• The LED display will show “PSd”.
• Enter the password using the number keys 1, 2, 3, 4, 5, 6, 7, 8, 9 and ZERO. Up to 8 digits may
be entered (only the last 3 are displayed)
• Press
the
OK key to save the new password (make sure you remember the password as it will be
required next time to wish to enter
Configuration Mode).
2.2.8 Enabling remote dome control from a Vi400, Vi405, Vi600 or Vi605 Digital Recorder
Domes connected to the Vi-K2/Vi-K3 can be controlled remotely via Ethernet, PSTN or ISDN via a Vi400 or
Vi600 Videoswitch Digital Recorder (DVR). Use Vi-Connect as the remote access software. This provides a
virtual joystick.
•
Single Vi-K2/Vi-K3 When configuring the Vi-K2/Vi-K3, press
ALT and 10 to enable the remote
control feature (the display will show ”
--|”).
•
Multiple Vi-K2/Vi-K3 When configuring each of the keyboards except for the furthest in the daisy
chain from the DVR, press
ALT and 9 (the display will show ”---”). When
configuring the furthest in the daisy chain from the DVR, press
ALT and 10
(the display will show ”
--|”).
The Vi-K2/Vi-K3 that is connected to the DVR should be connected with a CAT5 cable (or equivalent) that
has all pairs connected.
2.2.9 Enabling remote dome control from a Vi200 Digital Recorder
Domes connected to the Vi-K2/Vi-K3 can be controlled remotely via Ethernet, PSTN or ISDN via a Vi200
Videoswitch Digital Recorder (DVR). Use Vi-Connect as the remote access software. This provides a virtual
joystick.
When configuring the keyboard or keyboards, press
ALT and 9 (the display will show ”---”).
Connect the Vi-K2/Vi-K3 to the DVR as for normal control. Add an additional control cable between RJ45
connector that is above the keyboard connector on the Vi200 and the keyboard loop “
IN” connector on the
Vi-K2/Vi-K3. Note that the cable should be wired as follows::
Vi200 Vi-K2/Vi-K3
Pin1----------------------Pin1
Pin2----------------------Pin2
Pin5----------------------Pin5
2.2.10 Camera/Unit Mode
To address multiple DVRs by entering unit 1-16 and camera 1-16 select this mode as follows: