4 using the vi-k2/vi-k3, 1 home, 2 camera selection – Videoswitch Vi-K3 User Manual
Page 18: 1 camera select mode, 2 camera/unit mode, Using the vi-k2/vi-k3, Home, Camera selection, Vi-k2/vi-k3 universal keyboard
Vi-K2/Vi-K3 Universal
Keyboard
Vi-K2 Universal Keyboard User Manual
16
4 Using the Vi-K2/Vi-K3
4.1 Home
To set the Vi-K2/Vi-K3 to its “home” state (Camera 1, Monitor 1 and Unit 1), and to call up the Preset 1 of all
connected domes, press these keys:
• While pressing the ALT key, press the DEF key. Release both.
4.2 Camera Selection
4.2.1
Camera Select Mode
Note that the
Camera Select mode must first be set up in the configuration before use (see section
To display a particular camera in full screen mode:
• Press
the
CAMERA key
Using the number keys
1, 2, 3, 4, 5, 6, 7, 8, 9 and 0, enter the number of the camera you wish to view.
You may enter one, two or three digits as required. In multi-unit systems, the appropriate DVR will
automatically be selected.
4.2.2 Camera/Unit
Mode
Note that the
Camera/Unit mode must first be set up in the configuration (see section 2.2.10).
The required DVR must be first be selected for controlling as follows:
• Press
the
UNIT key
• The LED display will show the letter ”U” followed by the currently selected unit number (1…16).
• Press one of the number keys 1, 2, 3…16 to select another unit. Each unit must be given a
different address : 1 (Master), 2, 3 etc. so that the correct one is selected.
To display a particular camera in full screen mode:
• Press
the
CAMERA key
• The LED display will show the letter “C” followed by the currently selected unit number (1…16).
• Press one of the number keys 1, 2, 3…16 to select another camera.