Kenwood KDC-4751SD - Manual (Page 13)

English
13
Continued to next page
Adjust [SETTINGS] mode settings
While listening to an iPod or KENWOOD Music
Editor media ...
1
Press the volume knob to enter
[FUNCTION] mode.
2 Turn the volume knob to select
[SETTINGS], then press to enter.
3 Turn the volume knob to make a
selection, then press to confirm.
See the following table for selection.
4 Hold to finish the procedure.
Item Selectable setting (Preset: *)
SKIP SEARCH 0.5% */ 1%/ 5%/ 10%: Sets the ratio of skip
when searching for a song in Music Search
mode.
MPLIST
DELETE YES: Deletes the saved My Playlist. ;
NO *: Cancels.
■ [MPLIST DELETE] is selectable only when the source is
“iPod”.
Discs that cannot be used
■ This unit can only play the CDs with:
■ Discs that are not round.
■ Discs with coloring on the recording
surface or discs that are dirty.
■ You cannot play a Recordable/ReWritable
disc that has not been finalized. (For the
finalization process refer to your disc
writing software, and your disc recorder
instruction manual.)
■ 3-inch CD cannot be used. Attempt
to insert using an adapter can cause
malfunction.
About Audio file
■ Playable Audio file
: AAC-LC (.m4a), MP3 (.mp3), WMA (.wma)
■ Playable disc media: CD-R/RW/ROM
■ Playable disc file format: ISO 9660 Level
1/2, Joliet, Romeo, Long file name.
■ Playable USB device or SD card file system:
FAT16, FAT32
Although the audio files are complied with
the standards listed above, the play maybe
impossible depending on the types or
conditions of media or device.
■ Detailed information and notes about the
playable audio files are stated in an online
manual on the following site:
www.kenwood.com/cs/ce/audiofile/
About USB device
■ This unit can play audio files stored on a
USB mass storage class device.
■ Install the USB device in the place where
it will not prevent you from driving your
vehicle properly.
■ You cannot connect a USB device via a
USB hub and Multi Card Reader.
■ Make sure all important data has been
backed up to avoid losing the data.
Handling discs
■ Do not touch the recording surface of
the disc.
■ Do not stick tape etc. on the disc, or use a
disc with tape stuck on it.
■ Do not use any accessories for the disc.
■ Clean from the center of the disc and
move outward.
■ Clean the disc with a dry silicon or soft
cloth. Do not use any solvents.
■ When removing discs from this unit, pull
them out horizontally.
■ Remove the rims from the center hole
and disc edge before inserting a disc.
B64-4799-10_01_E_English.indd 13 B64-4799-10_01_E_English.indd 13 11/01/06 15:05 11/01/06 15:05