Kenwood KDC-4751SD - Manual (Page 19)

English
19
Easy Pairing function
1 Press and hold to enter easy pairing
mode
“PAIRING” is displayed.
■ Any of the following is displayed
depending on cell-phone registration
condition:
– “SEARCHING”: When registering a cell-
phone for the first time.
– “(cell-phone name)”: When a cell-phone
has already been registered.
– “DEVICE FULL”: When maximum of
five cell-phones have already been
registered.
When registering a cell-phone for the first
time, registering a cell-phone
2
“SEARCHING” is displayed.
Search for the Bluetooth device.
When search is completed, “FINISHED” is
displayed.
3 Turn the volume knob to select a cell-
phone name, press to confirm.
4 Input the PIN code
■ Turn the volume knob to select the
number.
■ To move to the next digit, press ¢.
■ To delete the last digit, press 4.
5 Press the volume knob to transmit the
PIN code.
If “PAIRING OK” is displayed, registration is
completed.
When “CONFIRM PHONE” is displayed,
confirm connection with a cell-phone
operation.
6 The receiver is connected to a cell-phone,
with “HF CONNECT” displayed, and exits
the easy pairing mode.
■ If an error code is displayed during paring,
see <Troubleshooting> (page 33).
When a cell-phone has already been
registered, or maximum of five cell-phones
have already been registered/ selecting a
cell-phone
2
“(cell-phone name)” or “DEVICE FULL” is
displayed.
3 Turn the volume knob to select a cell-
phone name.
■ To register a new cell-phone, select “[DVC
SEARCH]” or “[DV SEARCH]”, then go to
“When registering a cell-phone for the
first time.”
4 Press the volume knob to set up the
cell-phone.
■ “✱(cell-phone name)”: The selected
Bluetooth device is busy.
■ “-(cell-phone name)”: The selected
Bluetooth device is on standby.
■ “ (cell-phone name)“: The Bluetooth
device is deselected.
■ If a cell-phone is already selected,
deselect it, and then select a different
one.
5 Press to exit easy pairing mode.
Deleting the registered cell-phone
2
“(cell-phone name)” or “DEVICE FULL” is
displayed.
3 Turn the volume knob to select a cell-
phone name.
4 Press and hold the volume knob to delete
the selected cell-phone.
“DELETE” is displayed.
5 Turn the volume knob to select “YES”,
then press to confirm.
“COMPLETED” is displayed.
Bluetooth Setup
Function of KDC-BT41U/ KDC-BT31U
B64-4799-10_01_E_English.indd 19 B64-4799-10_01_E_English.indd 19 11/01/06 15:05 11/01/06 15:05