Kenwood KDC-4751SD - Manual (Page 20)

20
English
9 Hold to finish the procedure.
■ To exit Bluetooth mode, press .
■ If there are 5 or more Bluetooth devices
registered, you cannot register a new
Bluetooth device.
Registering Special Bluetooth device
1
Press to enter Bluetooth mode.
2 Turn the volume knob to select
[SETTINGS], then press to enter.
3 Turn the volume knob to select
[PAIRING], then press to enter.
4 Turn the volume knob to select [S-DVC
SELECT]/ [S-DVC SEL], then press to
enter.
5 Turn the volume knob to select a device
name, press to confirm.
6 Go through the procedure step 4
of <Registering from this unit> and
complete the registration (pairing).
■ If the device name is not in the list, select
“OTHER PHONE”.
Selecting the Bluetooth Device
1 Press to enter Bluetooth mode.
2 Turn the volume knob to select
[SETTINGS], then press to enter.
3 Turn the volume knob to select
[PAIRING], then press to enter.
4 Turn the volume knob to select [PHONE
SELECT]/ [PHONE SEL], then press to
enter.
5 Turn the volume knob to select a
Bluetooth device name.
6 Press the volume knob to set up the
Bluetooth device.
■ “✱(Device name)”: The selected Bluetooth
device is busy.
■ “-(Device name)”: The selected Bluetooth
device is on standby.
■ “ (Device name)“: The Bluetooth device is
deselected.
■ If a cell-phone is already selected,
deselect it, and then select a different
one.
7 Hold to finish the procedure.
■ To exit Bluetooth mode, press .
Registering Bluetooth Device
(Pairing)
Registering from Bluetooth devices
1
Press SRC to turn on the power.
2 Start registering this unit by operating
the Bluetooth device.
By operating the Bluetooth device, register
the hands-free unit (pairing). Select
“KENWOOD BT CD/R-3P1” from the list of
connected units.
3 Input the PIN code (“0000”) in the
Bluetooth device.
Check that registration is complete on the
Bluetooth device. PIN code is set to “0000”
as the default. You can change this code.
Refer to [PIN CODE EDIT]/ [PIN EDIT]
under <Bluetooth Setup> (page 22).
4 By operating the Bluetooth device, start
hands-free connection.
Registering from this unit
1
Press to enter Bluetooth mode.
2 Turn the volume knob to select
[SETTINGS], then press to enter.
3 Turn the volume knob to select
[PAIRING], then press to enter.
4 Turn the volume knob to select [DEVICE
SEARCH]/ [DVC SEARCH], then press to
enter.
5 Press the volume knob to search for the
Bluetooth device.
When search is completed, “FINISHED” is
displayed.
6 Turn the volume knob to select a
Bluetooth device name, press to confirm.
7 Input the PIN code
■ Turn the volume knob to select the
number.
■ To move to the next digit, press ¢.
■ To delete the last digit, press 4.
8 Press the volume knob to transmit the
PIN code.
If “PAIRING OK” is displayed, registration is
completed. If the error message appears
even though the PIN code is correct, try
Registering Special Bluetooth device.
B64-4799-10_01_E_English.indd 20 B64-4799-10_01_E_English.indd 20 11/01/06 15:05 11/01/06 15:05